- Difficulty level
- Easy
- Estimated time
- 2 min
After summer, it is advisable to tighten the sauna hoops: the heat may have dried out the wood, and the hoops may have become too loose. Tightening is done on the nuts located under the structure, with a 19 mm socket and a ratchet wrench. Here is the step-by-step method.
Why tighten the sauna hoops after summer
The hoops keep the wooden slats of your sauna tightly pressed against each other.
During summer, the heat may have dried out the wood. Now, wood that dries shrinks slightly: this is the natural behavior of a living material like Red Cedar. The hoops can then become too loose. Tightening after summer restores the correct tension.
The right tools
The tightening nuts are located under the sauna structure. Given their position, plan for:
a 19 mm socket, 20 cm in length;
an extension, if needed, to work more comfortably;
a ratchet wrench, ideally.
How to Adjust Sauna Hoops
-
Locate the nuts under the structure
The straps are tightened using the nuts located under the sauna structure.
-
Attach the socket to the ratchet wrench
Secure the 19 mm socket onto the ratchet wrench. Add an extension if access to the nuts is difficult.
-
Tighten gradually
Tighten the nuts gradually, until you hear a slight creaking sound from the wood.
Tip: Tip: an impact driver To make tightening easier, you can use an impact driver. Proceed with short pulses to maintain gradual tightening, until you hear a slight creaking sound from the wood. Tighten on both sides of the sauna evenly, to balance the tightening.
-
Repeat for each hoop
Proceed in the same way for each of the sauna hoops.
Do you have questions about maintaining your sauna?
Our teams answer your questions about tightening the barrel bands and maintaining your wooden sauna.
FAQ
Why do sauna barrel bands loosen?
During the summer, heat can dry out the sauna wood. As it dries, the wood shrinks slightly, and the barrel bands that hold the planks in place can become too loose.
When should you tighten the bands on a sauna?
The key time is the end of summer. The heat can dry out the wood and loosen the bands: tightening them at this time restores the proper tension.
Do you need a tool to tighten the straps?
A 19 mm wrench is necessary, with a length of 20 cm. It is the only tool recommended for this operation.
How do you know if the sauna hoop tightening is sufficient?
After tightening the hoops on both sides, observe your sauna. If water is still seeping in or if a gap remains visible between the slats, tighten further. If in doubt, contact our after-sales service.
My sauna has stains on the wood and water is seeping in through capillary action: what should I do?
A slight water infiltration is normal, as are stains on the wood: it is the tannin that naturally emerges from Red Cedar. No intervention is necessary, as this natural aging adds to the charm of Storvatt products. If the infiltration becomes significant, tighten the bands.